Help concerning Dot´n Line
Frequently Asked Questions
- Adjusting of return plates
- Extruder Service?
- How to Adjust the sealing for the Extruder shutter?
- How to Change the sealing for the Auger of the Extruder pump
- Info concerning the Dot Rotor
- Lack of material pressure in extruder
- The Extruder/spray pumps is not regular
- When the extruder is up, it registers that it is in down position and the auger speeds up. When the extruder is down to be used it registers that it is in the up position for travel and the auger will not increase in speed to push out the correct amount.